Why Aren’t As Bad As You Think

Useful Tips for How to Replace a Cutlass Bearing

A cutlass bearing is a bearing on a vessel’s drive shaft log that is commonly made using brass and a lining that is grooved from the inside which is lubricated by the water which enters the grooves during rotation, this.

Regardless of the times when your boat is used, you must change the cutlass bearing in the long run. As soon as you realize it is time to make the cutlass bearing change you may find it hidden in the woodwork of the boat or some distance away from the keel.

Removing the cutlass bearing is not challenging however your hands will get dirty. These are the steps to follow to replace your boat’s cutlass bearing, now.

Prior to doing anything else, you should first locate the set screws so that you can remove them. In several cases, the set screws will be found hidden below the layer of growth and crud. Don’t forget that other boat manufacturers do not use set screws. If you already know that your boat does not have set screws, then it is not good to waste time looking for them.

Cutting the bearing is a must in the replacement of the cutlass bearing. If you don’t have a Sawzall with you, then a hacksaw should help you to cut the cutlass bearing. Using the Sawzall tool is something that requires you to have enough experience on how to use it.

Bending the cutlass bearing is the next step. Using a cold chisel and a hammer it is possible to bend the cutlass bearing to the inner side so that you get to the place where you have made the cut. Avoid using a lot of force when hitting the cutlass bearing so that it can bend. Do not force the cutlass bearing to avoid damaging the boat’s strut.

Put a maple dowel where you have created a space by bending the boat’s cutlass bearing inside and with a hammer slit it opens up to the other end. Avoid using any tool made of metal to split the cutlass bearing on its length. If you do so, you risk damaging the inside of the strut.

Finally, remove the cutlass bearing. To remove the cutlass bearing use a pair of pliers to hold. Install a new cutlass bearing after you clean the strut’s surface. After you remove the old cutlass bearing, cleaning the surface of the strut, and want to install a new cutlass bearing bought from Propeller Depot, make sure enter the acme props in a straight line.

If the ramrod strut is forced and not straight it, you may damage it. So that the ramrod of the strut can go in straight use some grease on the cutlass bearing to help it to slide in easily.